Welcome to BroadbanterBanter. |
You are currently viewing as a guest which gives you limited access to view most discussions and other FREE features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload your own photos and access many other special features. Registration is fast, simple and absolutely free so please, join our community today.
|uk.telecom.broadband (UK broadband) (uk.telecom.broadband) Discussion of broadband services, technology and equipment as provided in the UK. Discussions of specific services based on ADSL, cable modems or other broadband technology are also on-topic. Advertising is not allowed.|
| ||Thread Tools||Display Modes|
Replacing Attenna On Wireless Access Point
I have seen kits to locate the aerials on bits of cable to cover blind spots
etc... some WLAPs even support "Diversity mode" (both aerials) or you can
select which it uses... this is (AIUI) primarily to allow a single antenna
to be located away from the unit but the WLAP to be in an office somewhere.
(near the ethernet)
"Tiny Ramsden" wrote in message
The Natural Philosopher wrote:
On Mon, 30 Jun 2003 22:08:14 +0100, Dean wrote:
Sorry if this is off topic but its related to me sharing an broadband
Does anyone know if its possible to replace an atenna on a wireless
point so it could be relocated outside?
The impedance and characteristics of the atenna is matched very closely
to the transmitter/receiver.
Adding a cable between the two will upset this
I would say it is unlikly to work unles you have access to
some very specialised test equipment to set it up.
The gear I helped set up last week to light up a business park was
freeely being plugged into several differnet styles and gains of
internal and external aerials with varying lengths of cable.
Software interrogation of the ethernet based wireless access points
seemed to be enough to establish signal strength amd error rates.
The harder part might be getting hold of teh kit you need in terms of
decent cable and plugs etc.
Wireless Anntennae, Connectors, cables, plugs, and sockets can be found on
the Lioncom site under wireless accessories.
Lioncom adsl 4 port router, Nildram adsl running on Redhat 7.3. You can
and hear me and my pal Joe Longthorne on uktalent.org.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Replacing Attenna On Wireless Access Point||The Natural Philosopher||uk.telecom.broadband (UK broadband)||1||July 5th 03 10:38 PM|