Hi Does anyone know if it's possible to run a U.S. Robotics USR805410 100Mbps Wireless Cardbus Adapters on a desktop easily? How can this be done? Can i Buy adaptrs - how much are they? Thanks a lot! D

In article , "Chickenbomb" says... i have a pc which is connected to the interent thru a cable modem (ntl), and i have just got a second tower unit, and i would like to if possible connect the tower, so i can have it running, without the need for an additional monitor? so is this possible, and what "tools" will i need to...

In article , "BORG" says... Not worried about sharing internet connection, will be used for file sharing only, HDDs in a small comp in cupboard and lappy on desk as main computer. Is there a question in there somewhere? :-)

Hello, I've been fighting to re-install a Buffalo Air Station Router WBR-B11/G54 and a repeater bridge WLA 54c. I'm looking for someone living in or near North London who is knowledgeable about wifi (preferably also familiar with Buffalo products) who would be interested in doing this in return for a suitable fee. All that is involved is plugging in and installing in into my PC. My system is...

Might not be the correct newsgroup but networking folk are very worldly wise. Naturally I know of networking WiFi, DECT phones transmit signals, there are video transmitters, I know low voltages are being transmitted to enable Access Points to be mounted away from power supplies so I am wondering what else can be transmitted without wires. Geoff Lane

I have just purchased a Netgear WGE101 bridge and I am having real difficulty setting it up. Could someone plese explain what I need to do. Currently I have my Xbox connected to my router via a patch cable. My xbox has an IP address of 192.168.0.193 and this works successfully. What I want to do is connect my xbox to the WGE101 bridge and move the PC and router upstairs. When I connect the...

Ian Stirling wrote in : In that case, it should almost certainly work fine. Ensure any PCI cards that you use have antennas that can be seperated out a bit from the card, on a short bit of cable. Otherwise, you can run into problems with the PCs shielding the signal. I'd say this is your best...

I am sharing part of my network with a third party. The third party is connected to my hub, which allows access to the internet. We are connected externally via a Netgear broadband router. I am looking for a low cost hardware firewall device which will enable me to prevent unauthorized traffic between my half of the network and the third party, which is on my side of the router.

My current setup: 1 Belkin modem router connected only to my Broadband phone line (no hardwire connection to any computer) 2x desktop PCs each with USB external wireless network adapters (not access points) 2x laptop PCs, one with built-in WiFi, the other with a network adapter card in PCMCIA slot All machines running Windows XP Home except for one of the laptops which has XP Pro.

In , AF typed: Hi i am looking for a second hand laptop, to go to college with, it needs to have USB, a 15 - 20 gb, descent ram, and a eztra good thing would be a cd-rw. I am looking to pay £250 - £300, it does not been to have a OS as i have a copy of xp pro. TIA

Acer Aspire 1300 Back in June I posted a message about a DUN problem, message ID below. I had, numerous useful replies though none of which solved the problem. Very briefly my home adsl broadband works fine but DUN fails to connect after making all the normal sqwaking noises.

Hi guys....I have a little bit of a problem, I'm new to netoworking. have a Linksys WRT54GS wireless router. But my Printer and my compute are plugged directly into the router. The Printer is a Xerox Phase 8200, which has a network card in it. I connected the printer, and se up an IP address for the printer using the control panel on the printe itself. I made sure the IP was similar, but...

I unplugged my netgear DG834G last night because the adapter plug (uk model) was buzzing very loudly and was very hot to the touch. I plugged it back in this morning and is seems quiet and cool so far. My question do DG834G owners is this - is the buzzing and hotness of the adapter normal or do I have a faulty adapter? On a related note, how can I determine if my router modem is at fault...

Broadcast this solo ad to your database. It never fails to get high responses. Out of 5000 email subscribers, approximately $47,642.85 worth of orders can be made and 40 % goes to you = $19,057.14 Not bad for a 5 minute job! Why will you make so much money for one single post? By sending out this letter, your readers will gain free access to Stephan Ducharme’s new AUDIO ebook "Millionaire at...

Hi, just got a Linksys Wireless Gaming Adapter, and I was wondering if anybody else has experienced this same problem. I put the setup CD into the computer, and it has me connect the gam adapter directly into my PC's ethernet card with the cable they gav me. Then I click setup, it starts searching for the adapter, an tells me no adapter can be found.... If I plug the adapter into...

Hi I've been trying to set up a simple network at a friend's house. His basic setup is a desktop, and a laptop, both running XPHome. I've manually set the IP addresses as 192.168.0.1 and 192.168.0.2, both with subnet mask 255.255.255.0. Both machines have the same workgroup, and both have file sharing enabled. They are connected via a crossover cable.

Can anyone recommend a decent wireless ADSL modem/router/firewall and wireless desktop PC adapter please? ... and where I might obtain them, as cheap as possible please! To be used for home networking to allow sharing of adsl broadband connection. Cheers :-) --

Jet99 Hits 143,204 Member! http://www.jet99.com/ammaritravel There has to be a Good Reason 10,569 joined yesterday Jet99 Hits 143,204 Members today http://www.jet99.com/free_flying There has to be a Good Reason 10,569 joined today We have the PRODUCT! (Well over value of 1 time entry fee) We have the PAY PLAN ($100,2500,$2500+Matching Bonus program)

Hope someone can help. I have read the articles at http://www.practicallynetworked.com/sharing/troubleshoot/ & http://www.careyholzman.com/netfixes.htm but they do not help with my exact problem. My ME to XP peer to peer workgroup has always worked fine, no problems , I use ICS too. However, I added a large 2nd HDD to the XP PC, and formated it NTFS, (the C: drive is Fat32) Now, whenever I try to...

I've got a small home network with mixed Ethernet and WiFi. Having recently downloaded a packetsniffer and seen asterisk passwords (POP Mail) transmitted as plain text I am wondering how secure network transmissions really are. Currently on my WiFi I've got no encryption but have got MAC access, my immediate neighbour has trouble finding the ON switch of his computer and in my own house I lose...